| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Trading Board A > Message
Main Menu

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: neeed software for my eprom programer promac model 2a

Date: 07/19/02 at 11:16 AM
Posted by: Raj Patel
E-mail: rajkpatel@freeuk.com
Message Posted:

In Reply to: Re: neeed software for my eprom programer promac model 2a posted by Ivan Rohde on 02/14/02 at 6:42 AM:

To all who are interested:

I have the complete 62-page User Guide for the PROMAC 2A. The address on the back is 'JMC Japan Macnics Corp., 516 Imaiminami-cho, Nakahara-ku, Kawasaki-City, Kanagawa-ken 211, Japan TEL: (044) 711-0330 FAX: (044) 733-7150'.

I use a standard CENTRONICS Printer cable to transfer files to the programmer using the DOS command:


Where is the name of your file.
Before using the above command, set your programmer to receive by pressing 'FUNCTION C'.
'FUNCTION 5' lets you select the HEX data format.

As far as I am aware, there is no software available to control this programmer, although the manual does give details of the commands you can use to remotely control it.

Tell me what you are trying to do with the programmer and I will try to scan and send you the relevant sections of the manual.

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.