| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Technical Forum > Message
Main Menu

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Circuits on using Ultrasonic Transducers

Date: 02/13/00 at 3:07 PM
Posted by: Brian Snell
E-mail: bsnell@lara.on.ca
Message Posted:

In Reply to: Circuits on using Ultrasonic Transducers posted by Don on 02/03/00 at 3:40 PM:

: I would like to do some design work with ultrasonic motion transducers to detect objects but are fing it hard to locate circuits.

Reply: I have a simple design for a 40KHz transducer setup. This was used to detect clear film sections in a high speed film rewinder. It operates over a few inches and runs on 9 to 12 vdc. If you like, I can send you the schematic. Please advise.

Brian Snell.

Follow Ups:

Post a Follow-up:

No Follow Ups for this message is needed here. Please use the following link to go back to the current board of this forum. You could create a new thread there if it is needed.

[ Go Back ]

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.