| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Technical Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: More information : Siemens DL1416T programming

Date: 07/29/02 at 5:07 AM
Posted by: Thierry COQUARD
E-mail: tcoquard01@noos.fr
Message Posted:

In Reply to: Re: Siemens DL1416T datasheet needed - pinout posted by Mikaella Newson on 02/22/02 at 3:45 PM:


D5 1 20 D6
D4 2 19 Gnd
D0 3 18 Vcc
D1 4 17
D2 5 16
D3 6 15
/CE 7 14
/W 8 13
/CU 9 12
A0 10 11 A1

/CE : circuit enable : must be active in order to recieve the Write signal (/W)
/CU : cursor mode :
- when low, turns cursors (all segments on) on or off over the 4 characters when receiving the Write signal , depending on the D0-D3 input mask. Cursors are displayed only for the visible ASCII characters (>= $20)
- when high, the normal writing mode is enabled (A0-A1 to choose the character position, and D0-D6 to choose the ASCII code)

The valid ASCII codes seem to be in the range $20 to $5F (i.e. no lowercase and other characters from $60 to $7F)


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.