| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Technical Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: low voltage relay controlling AC power

Date: 02/02/02 at 4:18 PM
Posted by: Brian Snell
E-mail: bsnell@lara.on.ca
Message Posted:

In Reply to: low voltage relay controlling AC power posted by BC on 01/30/02 at 9:36 PM:

You would probably be better advised to use a triac as the lamp-switching device and turn it on from an optocoupler enabled from your logic signal via a current-limiting resistor. If your logic source does not have much driving power you may have to insert a buffer/driver to fed the LED section of the optocoupler. If you want further help with this please advise.


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.