[ Post a Follow-up ][ New Thread ]
Subject: [Announce] Job shop looking for work(MN)
Posted by: Greg Bratvold
E-mail: bratvold(at)mn(dot)mediaone(dot)net(no spam)
Minnesota job shop looking for new customers.
Small but advanced machine shop in Minneapolis
seeks long term machining work.
Equipment. 1. Hardinge CHNC chucker lathe
5 HP. 1.62" thru spindle.
2. Haas VF1 vertical machining
center. 7.5 hp. W 4th axis.
3. EdgeCam programing system
full version.(4th axis prog.,
surfacing, nurbs translation)
4. Manual mill, lathe and surface
Shop rate $30/hr. Contact Greg.
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Manufacturing
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.