[ Post a Follow-up ][ New Thread ]

Date: 10/14/99
Posted by: Peter Murphy
E-mail: spudp(at)clear(dot)net(dot)nz(no spam)
URL: http://

I think this is a French Standard (well we assume it is) as it is detailed on a drawing of a yacht keel, used for washers and keel bolts. I am looking for the equivalent standard in either ASTM, ISO or AS. Any help given would be very much appreciated on its composition especially the Aluminium, Silicon and Iron content. Also information on it tensile strength in Mpa and It elongation tolerance. Thanks in advance Peter Murphy

This message has been here for a period of time, a follow-up seems unnecessary. In this place we have stopped the functions of [post a follow-up]. To discuss and communicate your ideas/info, you may use our new message boards, please go to: Manufacturing Community

When you do want to contact the author of this message, you must replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail address above. But, please do not spam...

To create a new thread, please go to the current board of discussion forums. On that page, click the [Post a Message] or [New Thread] link, then you will find the submit form.

There are more than 55 boards in our site. Please choose, according to your topics, an appropriate one to post your message. If you are new comers, we suggest you to go to our Homepage to have a clear knowledge of the subjects and the orientations of our site before you post any messages.