[ Post a Follow-up ][ New Thread ]

Date: 10/14/99
Posted by: Jim
E-mail: jc333(at)hotmail(dot)com(no spam)
URL: http://

We are a company based in Hong Kong specializing in the manufacture of women's accessories. In our manufacturing process we are required to use powder coating for our products, specifically the bra wire tips. We are currently researching for different types of powders that can be used for this purpose. At present we use thermoset powders which are applied by electrifying the wire then dipping into the powders and then cured. We would like a nylon powder (low temp preferred) that can be coated over a PET wire and also wires which have been coated using "Rilsan PA11 type powders". Requirements for the new powder should have a strong bonding with the two coatings and strong impact resistance. If anyone should have any recommendations, please email me. Regards

This message has been here for a period of time, a follow-up seems unnecessary. In this place we have stopped the functions of [post a follow-up]. To discuss and communicate your ideas/info, you may use our new message boards, please go to: Manufacturing Community

When you do want to contact the author of this message, you must replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail address above. But, please do not spam...

To create a new thread, please go to the current board of discussion forums. On that page, click the [Post a Message] or [New Thread] link, then you will find the submit form.

There are more than 55 boards in our site. Please choose, according to your topics, an appropriate one to post your message. If you are new comers, we suggest you to go to our Homepage to have a clear knowledge of the subjects and the orientations of our site before you post any messages.