| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Help Wanted Bulletin Board > Archives
Main Menu
Find

[ Post a Follow-up ][ New Thread ]

Subject: Machining slate

Date: 10/13/99
Posted by: charles
E-mail: charles(at)dalkey(dot)demon(dot)co(dot)uk(no spam)
URL: http://

Message:

I have some pieces of slate 1" thick that require some 1/8" blind grooves and some 1/4" holes one of which is counter-bored to take a nut. Any suggestions as to how to go about the job would be most welcome. Type of cutters and whether I could make them myself. It is a one-off job but very important.

Post a Follow-up:

This message has been here for a period of time, a follow-up seems unnecessary. In this place we have stopped the functions of [post a follow-up]. To discuss and communicate your ideas/info, you may use our new message boards, please go to: Manufacturing Community

When you do want to contact the author of this message, you must replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail address above. But, please do not spam...

New Thread:

To create a new thread, please go to the current board of discussion forums. On that page, click the [Post a Message] or [New Thread] link, then you will find the submit form.

There are more than 55 boards in our site. Please choose, according to your topics, an appropriate one to post your message. If you are new comers, we suggest you to go to our Homepage to have a clear knowledge of the subjects and the orientations of our site before you post any messages.

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.