| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Help Wanted Bulletin Board > Archives
Main Menu
Find

[ Post a Follow-up ][ New Thread ]

Subject: Residual Molybdenum in 17-4PH

Date: 09/07/99
Posted by: Lee Seymour
E-mail: lseymour(at)castingtechnology(dot)com(no spam)
URL: http://www.castingtechnology.com

Message:

We have received a Master Heat from our alloy supplier with a "residual" Mo of 0.43%. We have now had several lots fail the 180 ksi tensile requirement for AMS 5344D in the range of 174 - 179 ksi. The yield (160 ksi min) is between 162 and 167 ksi; the elongation (6% min) is 12% and over and the red of area (15% min) is over 25%. Since the furnace charts and furnace calibration checks out, we are looking at the effect of the moly on the transition points of the alloy.

Post a Follow-up:

This message has been here for a period of time, a follow-up seems unnecessary. In this place we have stopped the functions of [post a follow-up]. To discuss and communicate your ideas/info, you may use our new message boards, please go to: Manufacturing Community

When you do want to contact the author of this message, you must replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail address above. But, please do not spam...

New Thread:

To create a new thread, please go to the current board of discussion forums. On that page, click the [Post a Message] or [New Thread] link, then you will find the submit form.

There are more than 55 boards in our site. Please choose, according to your topics, an appropriate one to post your message. If you are new comers, we suggest you to go to our Homepage to have a clear knowledge of the subjects and the orientations of our site before you post any messages.

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.