[ Post a Follow-up ][ New Thread ]
Subject: Ceramic tools for high speed machining
Posted by: Arunachalam RM
E-mail: engp6259(at)nus(dot)edu(dot)sg(no spam)
i am looking for values of average unit
power requirement for turning, drilling
and milling of nickel based superalloys
especially Inconel 718 when using ceramic
cutting tools. most handbooks like metcut
and metals handbook have values only for
HSS & carbide tools but not for ceramics.
as i don't have the access to the new
editions of these handbooks which may have
it, if any one has it or knows the values,
could you give me the values or any other
references which will have it.
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Manufacturing
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.