[ Post a Follow-up ][ New Thread ]

Date: 01/11/00
Posted by: Harley Pebley
E-mail: hpebley3(at)medicalpriority(dot)com(no spam)
URL: http://

I have a project where I need a panel mount RJ-45 jack and I'm not sure anything like that exists. After a lot of web searching and stopping at a couple electronics supply stores, I've not found a solution. For the prototypes I just cut down a wallplate to the size needed and super glued it to the project box. I'd like something a bit more finished for the final products. What I'm envisioning is like is something like a standard LED holder where you drill a hole, pop the holder in the panel and then the LED in the holder. Does anyone know of something like this for RJ-45s or have ideas for alternate solutions? Thanks.

This message has been here for a period of time, a follow-up seems unnecessary. In this place we have stopped the functions of [post a follow-up]. To discuss and communicate your ideas/info, you may use our new message boards, please go to: Electrical and Electronic Community

When you do want to contact the author of this message, you must replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail address above. But, please do not spam...

To create a new thread, please go to the current board of discussion forums. On that page, click the [Post a Message] or [New Thread] link, then you will find the submit form.

There are more than 55 boards in our site. Please choose, according to your topics, an appropriate one to post your message. If you are new comers, we suggest you to go to our Homepage to have a clear knowledge of the subjects and the orientations of our site before you post any messages.