[ Post a Follow-up ][ New Thread ]
Subject: EDA "edwin nc" , matrix solving error on simulation
Posted by: Marc De Beule
E-mail: mdebeule(at)glo(dot)be(no spam)
I'm a new user of an EDA package called "edwin nc" version 1.46, attempting to use the mixed mode simulator.
So as a start, to keep it simple, I created a 10V voltage source connected to a voltage divider consisting of 2 resistors of 1K in series.
The problem is that on simulation the message matrix solving error appears.
I did the following to create the design and start the simulation:
-start schematics capture
-selected edit components
-component create as device and placed 2 resistors
-component create as symbol and placed @E from lib sim.esl
[ snip ]
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.