[ Post a Follow-up ][ New Thread ]

Date: 12/13/99
Posted by: Rick
E-mail: canislupus(at)mediaone(dot)net(no spam)
URL: http://

Wrong email address given previously. I'm looking for a simple circuit that illuminates an LED when either TxD or RxD are active. I'm thinking of simply using a NAND gate to drive an LED. Since the resting state of the TTL side is always high, any activity will always be preceeded by a low going signal(start bit). Someone suggested to me to also use a one shot in conjunction with it if I'm using this in a circuit that's 9600 or > as it'll be difficult to observe such a fast bit rate. Thank you

This message has been here for a period of time, a follow-up seems unnecessary. In this place we have stopped the functions of [post a follow-up]. To discuss and communicate your ideas/info, you may use our new message boards, please go to: Electrical and Electronic Community

When you do want to contact the author of this message, you must replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail address above. But, please do not spam...

To create a new thread, please go to the current board of discussion forums. On that page, click the [Post a Message] or [New Thread] link, then you will find the submit form.

There are more than 55 boards in our site. Please choose, according to your topics, an appropriate one to post your message. If you are new comers, we suggest you to go to our Homepage to have a clear knowledge of the subjects and the orientations of our site before you post any messages.