[ Post a Follow-up ][ New Thread ]
Subject: Rohde & Schwarz UDS5 DVM: GPIB commands
Posted by: Leif Mallon
E-mail: webmaster(at)leif-mallon(dot)de(no spam)
We use an old Rohde & Schwarz UDS 5 Multimeter. Now we'd like to program the GPIB-Interface via LabVIEW 5.0 but lost the handbook.
Has anyone experience in programming this device? Maybe someone already programmed some sort of LabVIEW driver?
Or could someone send us a list of GPIB commands of the UDS 5 via email or copies of the handbook section by mail (copies, p+p are payed, of course)?
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.