[ Post a Follow-up ][ New Thread ]
Subject: Circuit diagram of telephone line tapper
Posted by: nana osman
E-mail: o_nana(at)yahoo(dot)com(no spam)
I am doing a project on how to see the pattern of phone conversation (spurt or gap)..I try to connect the telephone line tapper to another circuit which is the gap detector. Gap detector is a circuit where it detects the spurt or gap pattern in the telephone conversation . This gap detector is connect to the EVB board (microprcessor controller , 68HC11). So , my problem is that i do not know how to build the circuit of the telephone line tapper and connect it to my gap detector circuit. For your information the gap detector circuit consist of two diodes and several resistors. When there is a gap diode 1 will blink and when there is a spurt , diode 2 will blink and diode 1 is off...Can u give me a suggection on how to tap the phone line . I have tried many circuit but everytime I run the program , the telephone is off hook. So I guess there's problem with the phone tap circuit. Can u give an opinion on how to go about it.....
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.