|
|
Main Menu
Find
[ Post a Follow-up ][ New Thread ]
Subject: How to etch a LARGE PCB....???
-
Date: 11/26/99
Posted by: David Roseman
E-mail: dmr220(at)psu(dot)edu(no spam)
URL: http://www.personal.psu.edu/dmr220/laser.html
-
Hola all!
I am to get a PCB (.015 double sided) and etch off 2 parts, F/B 3/4
around the edges, and 2" off the middle of one side...
Seeing that this is a 12x18" PCB, how the heck am I going to do the
middle??? What can I use to block the etchant? 5 coats of perm. marker?
tape of any kind?
and seeing that this is a THIN pcb, what is the best way to etch the
middle? bend and stick in etchant?
Post a Follow-up:
-
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail address above. But, please do not spam...
-
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics, an appropriate one to post your message. If you are new comers, we suggest you to go to our Homepage to have a clear knowledge of the subjects and the orientations of our site before you post any messages.