[ Post a Follow-up ][ New Thread ]
Subject: Christmas tree signal for drag racing
Posted by: Michael
E-mail: ickthoose2(at)yahoo(dot)com(no spam)
Looking for a schematic for building a "christmas tree" signal for our local
snowmobile club. They will use it for drag racing on the lake. Must be 12VDC
system (car batt.)
We would like to be able to adjust the delay between lights. Best senario
would be to hook it up to a car battery, turn it on and it would just keep
cycling until it was turned off.
Lights we are using are your standard 12vdc running lamps used on trailers
ect, with different colored lenses. Would like it to go red, yellow,green or
would settle for just red, green.
Any imput would be wonderful. Would like to build it as cheaply as possible
and remember that it gets -40 below up here!
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.