[ Post a Follow-up ][ New Thread ]
Posted by: Ron S.
E-mail: Rons993(at)aol(dot)com(no spam)
I have acquired a Sola 2KVA 110/220v super-isolation transformer, which I would like to use as a supply for my stereo power amp. However, I'm not certain what the best connection would be for the shield connections (primary and secondary), as well as the ground connections. It is currently wired with one side of the secondary winding tied to the ground connections(all shields and grounds wired with green/yellow stripe to a common ground bus). Is this the best configuration for isolation of audio equipment. Thanks for any help!
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.