[ Post a Follow-up ][ New Thread ]
Subject: LVDS signals
Posted by: Chris
E-mail: christopher(dot)connelly(at)gecm(dot)com(no spam)
I am currently designing a backplane that will carry alot of LVDS
signals (Low Voltage Differential Signals) externally to/from a unit.
I am aware of LVDS tracking guidelines such as impedance matching,
returns next to the active signal etc. however was wondering, if anyone
who has used LVDS, could advise of any problems that they may of
encountered, and how they overcome them.
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.