[ Post a Follow-up ][ New Thread ]
Subject: Q factor
Posted by: Boggie Lim
E-mail: boggilim(at)chollian(dot)net(no spam)
In capacitor's specification, there is a Q factor.
I 'd like to know what is Q factor, what affects to Q factor, If Q factor is high, does it mean good quality?
And how we can check Q factor?
Is there any formula to calculate?
What is the best way to improve and make high Q factor in ceramic trimmer capacitor using ceramic dielectric?
I am waiting for kind advice from international expert, and if you can recommend me the books which I can get enough information on this matter, it will be highly appreciated.
Thanks and regards.
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.