[ Post a Follow-up ][ New Thread ]
Subject: 220v50 Hz 6 KW IGBT- AUTOMOTIVE - WINDMILL - PROPANE GEN - WATERCOOLED GENERATOR
Posted by: Torbjørn Homelien
E-mail: tobitze(at)powertech(dot)no(no spam)
DESIGN HELP?? I am trying to develop a IGBT inverter with Intelligent Power Module for 2-10 KW area. Output should be 220 v 50 Hz min.2,5 KW for "small" vindmill & car use.Next size should be 4,5 KW and 6 KW + 10 KW.It seems to me that most of the producers of IGBTs have an EVALUTATION BOARD, but the SAME board from 1-10 KW !? How can this be ?
2) What gives the 220 volts, is this ONLY given in the generator source, and a very little Voltage loss in the IGBTs ?
3) Is the construction very sensitive on waveform of Generator, or will the "good quality sine wave" come from a reference sinus at the controlelr board ?
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.