[ Post a Follow-up ][ New Thread ]
Subject: Positional Servomechanisms.
Posted by: tamer
E-mail: tamer(dot)mustafa(at)ukgateway(dot)net(no spam)
> Can anyone tell me if there is any information on the net or any relevent
> books on building positional servomechanisms?
I need to build one in order to lift a small shaft a certian distance. Ideally i was thinking on using a closed loop feedback PID controller to control a DC motor. So far all of the books I have looked at are not practical enough and seem not to give any information on the building aspects.
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.