[ Post a Follow-up ][ New Thread ]

Date: 07/29/99
Posted by: Jeff Fulcer
E-mail: jfulcer(at)startingpoint(dot)com(no spam)
URL: http://

I need to create a circuit that when a 24vdc 3 amp source is applied to the circuit, it will allow the juice to flow for about 1/2 second (1 second would be maximum) and then cut the signal off. After the power is removed, the circuit would need to reset itself quickly. Heat is an issue, as there will be able 15-20 of these in a 1 cu ft box. I don't mind putting a fan in but would prefer not to. The normal state of these circuits is going to be where the power is being cut off. Thanks! Jeff

This message has been here for a period of time, a follow-up seems unnecessary. In this place we have stopped the functions of [post a follow-up]. To discuss and communicate your ideas/info, you may use our new message boards, please go to: Electrical and Electronic Community

When you do want to contact the author of this message, you must replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail address above. But, please do not spam...

To create a new thread, please go to the current board of discussion forums. On that page, click the [Post a Message] or [New Thread] link, then you will find the submit form.

There are more than 55 boards in our site. Please choose, according to your topics, an appropriate one to post your message. If you are new comers, we suggest you to go to our Homepage to have a clear knowledge of the subjects and the orientations of our site before you post any messages.