[ Post a Follow-up ][ New Thread ]
Subject: Dynamic frequency multiplier
Posted by: Paul van Roosmalen
E-mail: paul(dot)vanroosmalen(at)km-ehv(dot)comp(dot)philips(dot)com(no spam)
I'm looking for a dynamic frequency multiplier capable of multiplying an
input frequeny between 1.5 kHz and 4.2 kHz by a factor of 8.
It is meant to operate during a frequency sweep of the input frequency from
4.2 kHz down to 1.5 kHz. This sweep should take about 42 minutes.
The output frequency has to be very accurate. The maximum allowed error
should be smaller than 0.1% of the periode of the generated square wave.
Can anybody help me?
Thanks in advance,
Post a Follow-up:
This message has been here for a period of time, a follow-up seems
unnecessary. In this place we have stopped the functions of [post a
follow-up]. To discuss and communicate your ideas/info, you may use our
new message boards, please go to: Electrical
and Electronic Community
When you do want to contact the author of this message, you must
replace the "(at)" with "@" and "(dot)" with "." in his/her e-mail
address above. But, please do not spam...
To create a new thread, please go to the current board of discussion forums.
On that page, click the [Post a Message] or [New Thread] link, then you will find
the submit form.
There are more than 55 boards in our site. Please choose, according to your topics,
an appropriate one to post your message. If you are new comers, we suggest you to go
to our Homepage to have a clear knowledge of the subjects and the orientations of
our site before you post any messages.